FOAMULAR® Insulation Product Selection Guide
All Foamular XPS products are R-5 per inch of thickness except High-R CW Plus that is R-10 at 1-3/4″, and R-12 at 2 1/8 ” thick.
Construction Application | FOAMULAR® Product | ASTM C578 Type | Comments |
---|---|---|---|
General Purpose | FOAMULAR® 150 | X | Slab edge, foundation, under light slab, steel stud sheathing, masonry cavity wall, concrete tilt-wall, etc. For roofing applications, use Thermapink®. |
FOAMULAR® 250 | IV | ||
Wall | |||
Sheathing | FOAMULAR® Insulating Sheathing | X | Laminated film on both sides for added strength. |
PROPINK® | X | Reinforced laminated film on both sides for added strength. | |
Masonry Cavity Wall | CW15 | X | 15 and 25 psi, 16″ wide, fits between wall ties. |
CW25 | IV | ||
High-R CW Plus | IV | 25 psi, 16″ wide, fits between wall ties. Higher R per inch. | |
Furring | INSULPINK® | X | Notched to accommodate 1x wood furring on inside surface of unit, masonry or concrete walls. |
INSULPINK® Z | X | Fits between Z-furring on inside surface of unit masonry or concrete walls. | |
Insulated Concrete Sandwich Panels | FOAMULAR® 250 | IV | Used with low conductivity, metal or other composite grid-type wall ties. |
Exterior Insulation Finish System, EIFS | FOAMULAR® 250 | IV | Parex I-C Gold with Foamular 250. |
Roofing | |||
Low Slope Commercial Roofing | THERMAPINK® | IV | 18, 25 psi, used in a variety of roofing systems over a variety of deck types. |
Architectural Metal Roofing | |||
PRMA, Plaza Deck, Waterproofing | FOAMULAR® 404 | VI | Bottom side drainage channels on 4 edges for PRMA. |
FOAMULAR® 604 | VII | ||
FOAMULAR® 400 | IV | High load, vehicular traffic. | |
FOAMULAR® 600 | VII | ||
FOAMULAR® 1000 | V | ||
Under Slab | |||
Load Bearing, High Strength, Under Industrial Slabs | FOAMULAR® 400 | VI | 40, 60, 100 psi compressive strength. Engineer to match Foamular compressive needed to load on slab and slab design. Ranges from light pedestrian to heavy equipment and storage. |
FOAMULAR® 600 | VII | ||
FOAMULAR® 1000 | V | ||
Under Slab, Low Temperature Storage | FOAMULAR® LT30 | IV | 30 psi. Light to medium load. |
FOAMULAR® LT40 | IV | 40 psi. Heavier load. | |
Foundation | |||
Below Grade Walls | INSUL-DRAIN® | IV | Filtration fabric faced with drainage channels in foam. |
PINK-DRAIN® | IV | Channel design prevents soil from clogging channels assuring long-term performance. |